DTC C0240

Circuit Description

The PCM monitors various parameters and will not allow traction control operation if any parameter falls below a specified value.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The PCM detects a malfunction and then causes TCS shut down until the malfunction has been corrected.

Action Taken When the DTC Sets

If equipped, the following actions occur:

• A DTC C0240 is stored.
• The TCS is disabled.
• The TRAC OFF indicator is turned on.
• If the TCS is again allowed to function, the indicator will be turned off but the DTC will be stored.

Conditions for Clearing the DTC

• The condition for the DTC is no longer present and the DTC is cleared with a scan tool.
• The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Diagnostic Aids

• Thoroughly inspect the wiring and the connectors. Failure to carefully and fully inspect the wiring and the connectors can result in misdiagnosis. Misdiagnosis may cause replacement of parts without repairing the malfunction.
• If an intermittent malfunction exists, refer to Testing for Intermittent and Poor Connections in Electrical Systems.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

4. This step checks if DTC C0240 resets.

Step	Action	Yes	No
Schematic Reference: ABS Schematics
1	Did you perform the Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - ABS
2	Turn the ignition switch to the RUN position with the engine off. Using a Scan Tool, read the ABS/TCS DTCs. Are any other DTCs set?	Go to Diagnostic Trouble Code (DTC) List for the appropriate DTC table	Go to Step 3
3	Is DTC C0240 set as a current code?	Go to Step 5	Go to Step 4
4	Using the scan tool clear the DTC. Remove the scan tool from the DLC. Carefully drive the vehicle above 12 km/h (8 mph) for several minutes. Did DTC C0240 set as a current DTC?	Go to Step  5	Go to Diagnostic System Check - ABS
5	Perform the Powertrain OBD System Check. Refer to Diagnostic System Check - Engine Controls in Engine Controls-5.7L. Did the vehicle pass the OBD System Check?	Go to Testing for Intermittent and Poor Connections in Wiring Systems	Go to Step  6
6	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Does the DTC reset?	Go to Step  2	System OK